Toshiba DP120F Service Manual page 552

3.1.2 Paper Pickup Solenoid (Paper Tray/Optional Paper Tray) Gap
Adjustment
Install the paper pickup solenoid so that the gap between the claw of the clutch spring and the
armature of the paper pickup solenoid becomes 0.8 +0.2/-0.2mm while pulling the armature of
the paper pickup solenoid by the solenoid.
WARNING: Turn off the power and disconnect the power cord from the outlet.
(1) Disconnect the Telephone line cord.
(2) Remove the developer assembly with drum unit.
(3) To adjust the paper pickup solenoid (paper tray) gap, remove the main block. (Refer to
"2.4.20 Main Block.")
(4) To adjust the paper pickup solenoid (optional paper tray) gap, remove the optional tray
rear cover. (Refer to "2.6.5 Option Tray Rear Cover.")
(5) Turn the paper pickup roller until the claw of the clutch spring touches the armature of the
paper pickup solenoid.
(6) Loosen the one set screw of the paper pickup solenoid, insert the 0.8mm thickness gauge
between the clutch spring claw and the armature. Then tighten the one set screw of the
paper pickup solenoid.
(7) Turn the paper pickup roller until the claw of the clutch spring touches the armature again.
Check that the gap between the clutch spring claw and the armature is 0.6 to 1.0mm when
the armature is attracted by the paper pickup solenoid.
Clutch spring claw
DP120F/DP125F Removal/Replacement
Armature
Fig. 8-3-3
8-132
Paper pickup solenoid
(paper tray/optional paper tray)
March 2000 © TOSHIBA TEC
08-03-03