Toshiba DP120F Service Manual page 667

Code
Maintenance User
C2 85
C3 83
C4 83
D0 80
D1 82
D2 86
E0 21
E6 21
F0 83
F1 83
March 2000 © TOSHIBA TEC
Cause
After detecting the image signal,
carrier off was detected for more
than 1 second.
After detecting a high-speed sig-
nal, EOL was not detected for 15
seconds.
The EOL timer has timed out.
Post response signal was not de-
tected on the sending side.
Post signal was not detected on
the receiving side.
DCN is received.
RTN/PIN is received on the send-
ing side.
RTN/PIN is received on the re-
ceiving side.
A printer error occurred during a
reception, and the machine is
shifted into memory reception
mode. How ever, there was not
enough residual memory.
An error relating to the printer has
occurred.
The communication ended be-
cause of a WDT due to an over-
run of the software.
The communication ended be-
cause of an overrun of the soft-
ware due to hard-ware noises.
This may happen in some cases of
bad line condition. Ask the remote
party to transmit again.
This may happen in some cases of
bad line condition. Ask the remote
party to transmit again.
This may happen in some cases of
bad line condition. Ask the remote
party to transmit again.
This may happen in some cases of
bad line condition. Attempt the trans-
mission again. Or ask the remote
party to attempt the transmission
again.
This may happen in some cases of
bad line condition. Ask the remote
party to transmit again.
This may happen in some cases of
bad line condition. Ask the remote
party to transmit again.
Remove the cause of the printer er-
ror, then ask the remote party to
transmit again.
Confirm details of the error using the
error code and correct the error.
Then ask the remote party to trans-
mit again.
Attempt the communication again. If
the error occurs frequently, perform
a memory clear (except user area.)
Attempt the communication again. If
the error occurs frequently, perform
a memory clear (except user area.)
11-55
Remedy
DP120F/DP125F Troubleshooting