Toshiba DP120F Service Manual page 632

1.5.4 SENSOR TEST
This test checks the actions of various sensors. The results are displayed on the LCD in the
form of binary data. The displayed data will be changed by changing the state or status of the
applicable sensor.
Use the [ ↑ ] or [ ↓ ] key to select "04. SENSOR TEST", and then press the [ENTER] key.
(1)
SENSOR TEST
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
Bit 15
<Remarks>
(2) When you complete the check, press the [STOP] key to return to the standby mode
screen.
(3) Depending on the result of the test, replace the applicable sensor, Operation panel unit,
etc. referring to "Chapter 8 Removal/Replacement/Adjustment."
DP120F/DP125F Troubleshooting
← Upper Data
← Lower Data
Bit 0
The binary data on the LCD display means the following, and its set con-
tents are shown in the sensor test diagram on next page.
[MENU], [9], [4], [04]
11-20 March 2000 © TOSHIBA TEC