Toshiba DP120F Service Manual page 534

2.6.8 Optional Paper Pickup Solenoid
Before disassembling or reassembling, be sure to refer to "1. Before Disassembling or Reas-
sembling."
(1) Remove the optional recording paper tray block. (Refer to "2.6.1 Optional Recording Pa-
per Tray Block.")
(2) Remove the optional recording paper tray. (Refer to "2.6.2 Optional Recording Paper Tray.")
(3) Remove the optional tray left cover. (Refer to "2.6.3 Optional Tray Left Cover.")
(4) Remove the optional tray right cover. (Refer to "2.6.4 Optional Tray Right Cover.")
(5) Remove the optional tray rear cover. (Refer to "2.6.5 Optional Tray Rear Cover.")
(6) Disconnect the connector from CN4 on the optional tray PBA.
(7) Release the cable from the cord clamp.
(8) Remove the one screw from the optional paper pickup solenoid, and remove the optional
paper pickup solenoid.
CN4
Optional tray PBA
(9) Reassemble the components in the reverse order of disassembly.
NOTES: • When installing the optional paper pickup solenoid, perform the paper
pickup solenoid gap adjustment referring to the "3.1 Paper Pickup Sole-
noid Gap" on page 8-130.
• After reassembling, perform the print test referring to the "Chapter 11: 1.5.2
PRINT TEST" on page 11-18.
DP120F/DP125F Removal/Replacement
Fig. 8-2-142
8-114
Cord clamp
Optional paper
pickup solenoid
08-02-142
March 2000 © TOSHIBA TEC