Toshiba DP120F Service Manual page 645

1.6.6 EDGE REGISTRATION
This setting adjusts the recording start position (lead edge and side edge) if incorrect due to
mechanical dispersion. Do this adjustment when the Main PBA is replaced or when MEMORY
CLEAR is performed. Do it also when the LSU is replaced if necessary.
ing area
<Remarks>
Use the [ ↑ ] or [ ↓ ] key to select "06.EDGE REGISTRATION", and then press the [EN-
(1)
TER] key.
LEAD EDGE
[↑↓] FOR SETTING
Use the [ ↑ ] or [ ↓ ] key to set the LEAD EDGE (upper side), and then press the [ENTER]
(2)
key.
<Remarks>
<Remarks>
Use the [ ↑ ] or [ ↓ ] key to set the SIDE EDGE (left side), and then press the [ENTER] key.
(3)
SIDE EDGE
[↑↓] FOR SETTING
<Remarks>
<Remarks>
(4) The display shows the screen below, then returns to the standby mode screen.
COMPLETED
March 2000 © TOSHIBA TEC
↑ Feed direc-
Recording
paper
Lead edge
Side edge
For the adjustment value of edge registration, refer to "Chapter 8 Removal/
Replacement/Adjustment" on page 8-134.
+0.0mm
Pressing the [ ↑ ] key will move the image up 0.5mm per step.
Pressing the [ ↓ ] key will move the image down 0.5mm per step.
The setting range is -8.0mm to +8.0mm.
+0.0mm
Pressing the [ ↑ ] key will move the image left 0.5mm per step.
Pressing the [ ↓ ] key will move the image right 0.5mm per step.
The setting range is -6.0mm (Left) to +8.0mm (Right.)
[MENU], [9], [5], [06]
tion
Effective record-
11-33 DP120F/DP125F Troubleshooting