(2)
Reinstall the remaining components in the reverse order.
(3)
After assembling, set the Paper tray, turn the Power switch ON, and check the following:
• "Sensor test" in "Function test" of test mode.
(Refer to pages 11-20 to 11-21.)
• Load the document and press the [COPY] key. Check if copying and feeding normally
take place from both paper trays.
• Adjust the paper tray for different paper size, if required.
NOTE: Follow the same procedure to install an additional optional paper supply.
DP120F/DP125F Installation
3-22
March 2000 © TOSHIBA TEC