Unlocking The Developer Waste Exit - Kyocera FS-C8600DN Service Manual

Unlocking the developer waste exit

Caution
To ease setup, the device was shipped
with the developer unit already replenished
with developer. Therefore, to prevent
developer from spilling during shipping, a
developer shutter is equipped with the
developer unit.
To disengage the shutter, use the following
procedure: Note that if the shutter is not
completely disengaged and retained in
place, the developer in the developer unit
may clog at the outlet causing a damage to
the developer unit.
1. Remove the tape and then remove the
set up leaflet.
*: The setup leaflet must be affixed in posi-
tion before dispatching the machine.
2. Press the fixing pin in four positions and
rotate.
*: Fully insert the fixing pin keeping the line
vertical and rotate by 90 degrees clock-
wise. Make sure that the central line is
horizontal.
Tape
[Locked]
1
Fixing pin
1-2-14
Set up leaflet
[Released]
2
Fixing pin
Figure 1-2-21
2MN/2N1