Code
Contents
4202
BD steady-state error C
The BD signal is not detected.
4203
BD steady-state error M
The BD signal is not detected.
4204
BD steady-state error Y
The BD signal is not detected.
4300
Polygon motor phase error
ASIC won't settle in comple-
tion of phase adjustment for 2
s after a BD signal is
detected.
Causes
Defective connec-
Reinsert the connector. Also check for conti-
tor cable or poor
nuity within the connector cable. If none,
contact in the con-
replace the cable.
nector.
Laser scanner unit and LSU relay PWB
(YC10)
LSU relay PWB (YC3) and engine PWB
(YC12)
Defective PD PWB
Replace the laser scanner unit (see page 1-
C.
5-17).
Defective engine
Replace the engine PWB and check for cor-
PWB.
rect operation (see page 1-5-49).
Defective connec-
Reinsert the connector. Also check for conti-
tor cable or poor
nuity within the connector cable. If none,
contact in the con-
replace the cable.
nector.
Laser scanner unit and LSU relay PWB
(YC8)
LSU relay PWB (YC3) and engine PWB
(YC12)
Defective PD PWB
Replace the laser scanner unit (see page 1-
M.
5-17).
Defective engine
Replace the engine PWB and check for cor-
PWB.
rect operation (see page 1-5-49).
Defective connec-
Reinsert the connector. Also check for conti-
tor cable or poor
nuity within the connector cable. If none,
contact in the con-
replace the cable.
nector.
Laser scanner unit and LSU relay PWB
(YC12)
LSU relay PWB (YC3) and engine PWB
(YC12)
Defective PD PWB
Replace the laser scanner unit (see page 1-
Y.
5-17).
Defective engine
Replace the engine PWB and check for cor-
PWB.
rect operation (see page 1-5-49).
Defective laser
Replace the laser scanner unit (see page 1-
scanner unit.
5-17).
Defective engine
Replace the engine PWB and check for cor-
PWB.
rect operation (see page 1-5-49).
1-4-49
Check procedures/
corrective measures
2MN/2N1