Item No.
U147
Setting for toner applying operation
Description
Sets the mode for removing charged toner in the developing unit (T7 control: Toner applying
operation). Defines the action that the toner accumulated on the developer blade is sent back in
the developer unit (done by the vibration motor).
Purpose
The setting can be changed to reduce the toner applying quantity. Performed to change the
occurrence of the control of the vibration motor.
If the charged toner stays inside the developing unit, density decreases.
Method
1. Press the OK key.
2. Select the item to be set.
Display
Mode
Upper Limit
Minimum
Interval Number
Setting: [Mode]
1. Select the mode.
Display
Mode0
Mode1
Mode2
Initial setting; Mode1
2. Press the OK key. The setting is set.
Setting: [Upper Limit]
1. Change the setting value using the numeric keys.
Display
Value
2. Press the OK key. The value is set.
Setting: [Minimum]
1. Change the setting value using the numeric keys.
Display
Value
2. Press the OK key. The value is set.
Description
Settings for toner applying operation
Upper limit printing ratio of toner applying quantity with each mode
Toner layer width when cleaning mode is selected
Setting the vibration motor On timing
Less consumption of toner than a regular toner applying operation
Executes toner applying with the regular amount of toner
Applying more consumption of toner than a regular toner applying
operation
Description
Upper limit printing ratio of toner applying
quantity with each mode (%)
Description
Toner layer width when cleaning mode is
selected (mm)
1-3-78
Description
Description
Setting
range
0 to 2.0
Setting
range
0 to 30
2MN/2N1
Initial
setting
2.0
Initial
setting
10