Setting The Voltage For The Primary Transfer - Kyocera FS-C8600DN Service Manual

Item No.
U101

Setting the voltage for the primary transfer

Description
Sets the control voltage for the primary transfer.
Purpose
To change the setting when any density problems, such as too dark or light, occur.
Setting
1. Press the OK key.
2. Select the item to be set.
Normal
Add Color
Add Color 2nd
Surround Correct
Setting: [Normal]
1. Select the item to be set.
1. Change the value using the numeric keys.ll
Display
Full
Half
3/4
B/W*
*: 55 ppm model only.
2. Press the OK key. The value is set.
Setting: [Add Color]
1. Select the item to be set.
2. Change the value using the numeric keys.l
Display
Normal
Heavy4/5
3. Press the OK key. The value is set.
Display
Setting the primary transfer positive voltage
Setting the addition value (The addition value at the surface is
referenced as standard)
Setting the addition value for the second side
Environmental correction ON/OFF setting
Description
Primary transfer positive volt-
age for yellow (full speed)
Primary transfer positive volt-
age for yellow (half speed)
Primary transfer positive volt-
age for yellow at 3/4 times of
line speed
Primary transfer positive volt-
age for yellow in black/white
mode
Regular
Heavy 4/5
Description
Description
Setting
range
0 to 255
0 to 255
0 to 255
0 to 255
Description
1-3-52
Initial setting
45ppm 55ppm
126 131
108 110
118 118
- 135
Setting
range setting
-127 to 127 2
-127 to 127 2
2MN/2N1
Initial