Pf Lift Motor 1/2 Error (Large Capacity Feeder); Sd Lift Motor Error (Side Deck) - Kyocera FS-C8600DN Service Manual

Code Contents
1100 PF lift motor 1 error
(large capacity feeder)
After cassette 3 is inserted,
PF lift sensor 1 does not turn
on within 23 s. This error is
detected 5 times successively.
(Time to detect is 2 seconds
at the second time and later.)
During driving the motor, the
lift overcurrent protective
monitor signal is detected for
200 ms or more 5 times suc-
cessively. However, the first 1
s after PF lift motor 1 is turned
on is excluded from detection.
1110 PF lift motor 2 error
(large capacity feeder)
After cassette 4 is inserted,
PF lift sensor 2 does not turn
on within 23 s. This error is
detected 5 times successively.
(Time to detect is 2 seconds
at the second time and later.)
During driving the motor, the
lift overcurrent protective
monitor signal is detected for
200 ms or more 5 times suc-
cessively. However, the first 1
s after PF lift motor 2 is turned
on is excluded from detection.
1140 SD lift motor error
(side deck)
After cassette 5 is inserted,
SD lift sensor does not turn on
within 30 s.
The lock signal of the motor is
detected continuously for 200
ms.
Causes
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. PF lift motor 1 and PF main PWB (YC7)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for
tem of motor. broken gears and replace if any.
Defective PF lift Replace the PF lift motor 1.
motor 1.
Defective PF main Replace the PF main PWB (Refer to the ser-
PWB. vice manual for the paper feeder).
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. PF lift motor 2 and PF main PWB (YC7)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for
tem of motor. broken gears and replace if any.
Defective PF lift Replace the PF lift motor 2.
motor 2.
Defective PF main Replace the PF main PWB (Refer to the ser-
PWB. vice manual for the paper feeder).
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. SD lift motor and SD main PWB (YC8)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for
tem of motor. broken gears and replace if any.
Defective SD lift Replace the SD lift motor.
motor.
Defective SD main Replace the SD main PWB (Refer to the ser-
PWB. vice manual for the paper feeder).
1-4-32
Check procedures/
corrective measures
2MN/2N1