Setting The Applied Mode - Kyocera FS-C8600DN Service Manual

Item No.
U340

Setting the applied mode

Description
Allocates memory to ensure that there is sufficient memory available for the printer to use as a
working area.
Purpose
Modify the memory allocation if insufficient memory for transparency support or XPS direct print-
ing occurs.
Method
1. Press the OK key.
2. Select the item to set.
Adj Memory
Setting: [Adj Memory]
1. Change the setting using the numeric keys.
Display
Image
Image(Detail)
Set the values below in case print failure occurs with the memory shortage.
(recommended value)
Image : +190
Image(Detaile) : +1
2. Press the OK key. The value is set.
3. Exit the maintenance mode, perform shut-down, and turn the main power switch to off and on
again. Allow more than 5 seconds between Off and On.
Completion
Press the Back key. The screen for selecting a maintenance item No. is displayed.
Display
Setting the memory allocation
Area temporarily used to create output
image.
Area temporarily used to hold down-
loaded font and other data.
Description
Description
Description
1-3-114
2MN/2N1-1
Setting Initial
range setting
0 to 400 (MB) 190
0 to 400 (MB) 1