Setting The Finisher - Kyocera FS-C8600DN Service Manual

Item No.
U246

Setting the finisher

Description
Provides various settings for the 1000-sheet finisher or 4000-sheet finisher, if furnished.
Purpose
1. Adjustment of registration stop timing in punch mode
Adjust if skewed paper conveying occurs or if the print paper is Z-folded in punch mode.
2. Adjustment of paper stop timing in the punch mode
To adjust this item when the position of a punch hole is different from the specified one.
3. Adjustment of center position timing in the punch mode
Adjusts the center position of a punch hole in punch mode if the position is not proper.
4. Adjustment of front/rear side registration home position
Provides optimization when paper jam occurs due to an inferior fitting of the side registration
guides to paper.
5. Adjustment of front/rear shift home position
Performed when adjustment is lost with the ejected paper
6. Adjusting of front/back stapling home position
Adjusts the stapling position in the staple mode if the position is not proper.
7. Adjustment of upper/lower side registration home position
Provides optimization when paper jam occurs due to an inferior fitting of the side registration
guides to paper.
8. Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
9. Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
10. Adjustment of tri- folding position
Adjusts the tri-folding position in the stitching mode if the position is not proper.
Method
1. Press the OK key.
2. Select the item to set.
3. Press the OK key.
Finisher
Booklet
Method: [Finisher]
1. Select the item to set.
Punch Regist
Punch Feed
Punch Width
WidthFront HP
WidthTail HP
ShiftFront HP
ShiftTail HP
Staple HP
Display
Adjustment of 1000-sheet finisher and 4000-sheet finisher
Adjustment of center-folding unit
Display
1.Adjustment of registration stop timing in punch mode
2.Adjustment of the paper stop timing in punch mode
3.Adjustment of the center position timing in punch mode
4.Adjustment of front side registration home position
4.Adjustment of rear side registration home position
5.Adjustment of front shift home position
5.Adjustment of rear shift home position
6.Adjustment of front and back stapling home position
Description
Description
Description
1-3-96
2MN/2N1-1