Detaching The Fuser Drive Unit - Kyocera FS-C8600DN Service Manual

(3) Detaching and refitting the fuser drive unit, transfer drive unit and feed drive unit
Procedure

Detaching the fuser drive unit

1. Remove the rear upper cover and the
rear lower cover (see page 1-5-56).
2. Remove five wire holders of feed PWB
1 assembly.
3. Release the wire saddle.
4. Remove the following twenty connec-
tors from the feed PWB 1.
YC18, YC19
YC20, YC27
YC26, YC3
YC17, YC14
YC10, YC16
YC13, YC12
YC23, YC25
YC15, YC11
YC5, YC4
YC1 (FFC connector with a lock)
YC2 (FFC connector with a lock)
*: When removing the FFC from the FFC
connector with a lock, remove the FFC
after released by lifting down the lock
lever (see page 1-5-45).
Wire holder
Wire holder
Wire saddle
Wire holder
Figure 1-5-101
YC20
YC3
YC27 YC26
YC23
YC25
YC11
YC15
Figure 1-5-102
1-5-65
Feed PWB 1
assembly
Feed PWB 1
assembly
Wire holder
Wire holder
Feed PWB 1
FFC connector
with a lock
YC5
2MN/2N1