Cf Blade Motor Error; Cf Side Registration Motor 1 Error; Cf Main Motor Error - Kyocera FS-C8600DN Service Manual

Code Contents
8330

CF blade motor error

(4000-sheet finisher)
When initial operation, CF
blade sensor does not turn on
within 3 s.
8340 CF staple motor error 1
(4000-sheet finisher)
Staple JAM (center-folding
unit) has been detected twice
in a row. (The home position
could not be detected in 600
ms since the motor was driven
after jam was detected twice.)
8350 CF side registration motor 1
error
(4000-sheet finisher)
When initial operation, CF
side registration sensor 1
does not turn on within 1 s.
8360

CF main motor error

(4000-sheet finisher)
During driving the motor, lock
signal is detected for 1 s con-
tinuously.
Causes
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. CF blade motor and CF main PWB (YC15)
CF blade sensor and CF main PWB (YC20)
Defective CF blade Replace the CF blade sensor.
sensor.
Defective CF blade Replace the CF blade motor.
motor.
Defective CF main Replace the CF main PWB and check for
PWB. correct operation.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. CF staple unit and CF main PWB (YC13)
Defective CF sta- Replace the CF staple unit.
ple sensor.
Defective CF sta-
ple motor.
Defective CF main Replace the CF main PWB and check for
PWB. correct operation.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. CF side registration motor 1 and CF main
PWB (YC10)
CF side registration sensor 1 and CF main
PWB (YC20)
Defective CF side Replace CF side registration sensor 1.
registration sensor
1.
Defective CF side Replace CF side registration motor 1.
registration motor
1.
Defective CF main Replace the CF main PWB and check for
PWB. correct operation.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. CF main motor and CF main PWB (YC16)
Defective CF main Replace the CF main motor.
motor.
Defective CF main Replace the CF main PWB and check for
PWB. correct operation.
1-4-80
Check procedures/
corrective measures
2MN/2N1