For external wirings
Procedure
1. After confirming the data lamp is turned
off, perform shut-down on the operation
panel, turn power off, and unplug the
power receptacle(see page P.1-2-19).
2. Remove the pin of the card reader base
and then remove the card reader
mount.
3. Remove the upper right cover
(see page P.1-2-28).
4. Cut out the aperture plate on the upper
right cover using nippers
(see page P.1-2-31).
5. Replace the cover which was removed.
6. Fit the card reader mount to the
machine using two pins.
Figure 1-2-54
1-2-38
2MN/2N1-1
Right upper
cover