Kyocera FS-C8600DN Service Manual page 397

6. Remove two connectors from the hard
disk unit while pushing the lock lever.
Number of hard disk unit equipmentl: 1
7. Remove four screws and then remove
the hard disk unit from the HDD
bracket.
8. Replace the hard disk unit and refit all
the removed parts.
9. Perform maintenance mode U024
(HDD formatting) (see page 1-3-27).
10. Install the firmwares by the following
procedure.
1)Connects to the machine the USB
memory that preserved Software
LANGUAGE BR, JP (Opt Font,Opt
Msg), and the PDF1.7 resource.
The firmware is installed by switching
the main power switch to ON/OFF.
11. Perform maintenance mode U917
(backup data writing) (see page 1-3-
141).
Hard disk
unit
Lever
Connector
Screws
1-5-79
Lever
Connector
Figure 1-5-121
Screw
HDD bracket
Screw
Hard disk unit
Figure 1-5-122
2MN/2N1-1
Screw
Screws