Setting The Id Correction Operation - Kyocera FS-C8600DN Service Manual

Item No.
U464

Setting the ID correction operation

Description
Turns ID correction (calibration) on or off. Also, this allows individual settings for calibration oper-
ation.
Purpose
Implements various settings of calibration when poor image quality is caused or to allow various
settings of calibration depending on the user preference.
To perform the calibration when replacing the maintenance kit.
Method
1. Press the OK key.
1. Select the item to be set.
2. Press the OK key.
Permission
Time Interval
Mode
On/Sleep Out*
AP/NE*
Leaving Time*
Driving Time*
Timing*
Target Value
Print Rate(B/W)*
Calib
Edge Reduction
*: Enabled when Mode is set to Custom.
Setting: [Permission]
1. Select On or Off.
On
Off
Initial setting: On
2. Press the OK key. The setting is set.
Display
Setting to turn calibration on/off
Setting the interval time of calibration after printing
Setting the color print execution mode
Setting execution parameters for calibration when powered up
or reverted from auto-sleep
Paper interval calibration ON/OFF setting at the time of cali-
bration/near end after toner feed
Setting the standard time for judging whether or not to carry
out calibration based on the sleep time when the machine
recovers from the sleep mode
Setting the standard time for judging whether or not to carry
out paper interval calibration based on the driving time during
printing
Setting the standard time for judging whether or not to carry
out calibration based on the continuous print driving time dur-
ing printing
Setting the sensor target values for toner thick layer calibration
and light amount calibration
Setting the proportion of black/white printing at which black/
white calibration is executed during color printing.
Executing the calibration
Smoothing edge settings (automatic calibration is imple-
mented after settings are completed)
Display
Turns calibration ON
Turns calibration OFF
Description
Description
Description
1-3-118
2MN/2N1