Lift Motor 1 Error; Lift Motor 2 Error - Kyocera FS-C8600DN Service Manual

Code Contents
1010

Lift motor 1 error

After cassette 1 is inserted, lift
sensor 1 does not turn on
within 12 s. This error is
detected 5 times successively.
The lock signal of the motor is
detected continuously for 1 s.
This error is detected 5 times
successively.
1020

Lift motor 2 error

After cassette 2 is inserted, lift
sensor 2 does not turn on
within 12 s. This error is
detected 5 times successively.
The lock signal of the motor is
detected continuously for 1 s.
This error is detected 5 times
successively.
Causes
Defective bottom Check to see if the bottom plate can move
plate elevation smoothly and repair it if any problem is
mechanism in the found.
cassette.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Lift motor 1 and feed PWB 2 (YC3)
Feed PWB 2 (YC1) and engine PWB (YC4)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for
tem of motor. broken gears and replace if any.
Defective lift motor Replace the lift motor 1.
1.
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-49).
Defective bottom Check to see if the bottom plate can move
plate elevation smoothly and repair it if any problem is
mechanism in the found.
cassette.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Lift motor 2 and feed PWB 2 (YC3)
Feed PWB 2 (YC1) and engine PWB (YC4)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for
tem of motor. broken gears and replace if any.
Defective lift motor Replace the lift motor 2.
2.
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-49).
1-4-29
Check procedures/
corrective measures
2MN/2N1