Installing The Ic Card Reader Holder For Internal Wirings; Supplied Parts Of Ic Card Reader Holder - Kyocera FS-C8600DN Service Manual

1-2-5 Installing the IC card reader holder (option)
IC card reader holder installation requires the following parts:
Parts
IC card reader holder
Relaying USB wire
*
*1: For internal wirings only
Supplied parts of IC card reader holder (1709AD0UN0):
Parts
Card reader case
Card reader base
Card reader mount
Card reader tray
USB Wire (For extension)
Pin
Clamp
The card reader base, card reader mount, and the pin are packaged as an assembled kit.
For internal wirings
Procedure
1. After confirming the data lamp is turned
off, perform shut-down on the operation
panel, turn power off, and unplug the
power receptacle(see page P.1-2-19).
2. Pull the paper conveying unit out.
3. Remove two screws and then remove
the upper right cover.
Quantity Part.No.
1 1709AD0UN0 (option)
1 302MN46210
Quantity Part.No.
1
1
1
1
1
3 303NS24410
6 7YZM690002++H01
1-2-28
-
-
-
-
-
Paper conveying
unit
Figure 1-2-35
2MN/2N1-1
Upper right
cover
Screw
Screw