Setting The Fuser Control Temperature - Kyocera FS-C8600DN Service Manual

Item No.
U161

Setting the fuser control temperature

Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper,
or solve a fuser problem on thick paper.
Method
1. Press the OK key.
2. Select the item to be set.
WarmUp
Print
LowPower Mode
Grain Mode
Setting: [WarmUp]
1. Select the item to be set.
2. Change the setting value using the numeric keys.
Display
Ready
(C)
Ready
(E)
Ready
(P)
Drive
(C)
Wait
(C)
Low Power
(P)
F.S. Shift(C
Pressure(P)
3. Press the OK key. The value is set.
Display
Control temperature except at printing
Control temperature during printing
Heating power reduction control
Setting the grain mode
Description
Control temperature at dis-
playing Ready (Center)
Control temperature at dis-
playing Ready (Edge)
Control temperature at dis-
playing Ready (Press)
Stable temperature during
driving (Center)
Stable temperature during
halt (Center)
Control temperature at low
power consumption
(Press)
Full speed shift tempera-
ture (Center)
Pressurizing beginning
temperature (Press)
Description
Description
Setting
range
130 to 200 165
(°C)
100 to 200 140
(°C)
0 to 200 80
(°C)
130 to 200 170
(°C)
130 to 200 165
(°C)
0 to 200 150
(°C)
0 to 200 50
(°C)
0 to 200 155
(°C)
1-3-83
Initial setting
45ppm 55ppm
170
145
80
175
175
150
50
160
2MN/2N1