Position Adjustment Of The Stapler Unit - Toshiba e-STUDIO2330C Service Manual

28.4.2

Position adjustment of the stapler unit

When the stapler unit was replaced, adjust its installation position.
(1) Turn OFF the power of the equipment.
(2) Align a hole on the side of the stapler unit fixing screw and a hole on the lower plate. Then install
the stapler unit.
(3) When the stapler unit was installed, perform operation check. Then readjust the position of the
unit with scale marks, if required.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
SETTING / ADJUSTMENT OF OPTION
Fig. 28-83
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
28 - 40