NEC Univerge SV8100 Features And Specifications Manual page 290

Issue 5.0
Program
Program Name
Number
11-09-01 Trunk Access Code
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
11-10-27 Service Code Setup (for System
Administrator) – Trunk Port
Disable for Outgoing Calls
11-11-13 Service Code Setup (for Setup/
Entry Operation) – Display
Language Selection for Multiline
Terminal
11-12-01 Service Code Setup (for Service
Access) – Bypass Call
11-12-14 Service Code Setup (for Service
Access) – Trunk Group Access
14-01-01 Basic Trunk Data Setup – Trunk
Name
14-01-02 Basic Trunk Data Setup –
Transmit Level
14-01-03 Basic Trunk Data Setup –
Receive Level
14-01-07 Basic Trunk Data Setup –
Outgoing Calls
2 - 264
Description/Comments
If required, change the single-digit
Trunk Access Code (normally 9). If
you change this code, you must
also review the settings in
Program 11-01-01 for the new
code selected.
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Define the service code which
should be used by an extension
user to block a trunk from being
used for outgoing calls.
Select the service code which can
be used at an extension to change
the displayed language on a
multiline terminal display.
Define the service code for
Activating Call Forwarding/Do Not
Disturb Override. This code is
available only if you disable the
voice mail Single Digit dialing code
in Program 11-16-09.
Define the service code which
should be used by an extension
user to select outgoing Trunk
Group.
Set the names for trunks. The
trunk name displays on a multiline
terminal for incoming and outgoing
calls.
Customize the transmit and
receive levels of the CODEC Gain
Types for each trunk.
Customize the transmit and
receive levels of the CODEC Gain
Types for each trunk.
Allow or Deny outgoing calls on
the trunk you are programming.
UNIVERGE SV8100
Assigned Data
1
Dial (up to four digits)
(default = 9)
Dial (up to four digits)
(default not assigned)
MLT, SLT
(default = 645)
MLT
(default = 678)
MLT, SLT
(default = 707)
MLT, SLT
(default = 704)
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
0 = Deny (No)
1 = Allow (Yes)
(default = 1)
Central Office Calls, Placing
Level
2 3









