NEC Univerge SV8100 Features And Specifications Manual page 146

Issue 5.0
Program
Program Name
Number
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
44-03-01 Dial Analysis Extension Table –
Dial
44-03-02 Dial Analysis Extension Table –
ARS/F-Route Select Table
Number (1~250)
44-03-03 Dial Analysis Extension Table –
ARS/F-Route Select Table
Number (251)
44-03-04 Dial Analysis Extension Table –
Next Table Area Number (252)
2 - 120
Description/Comments
Determine if the Dial Tone
Simulation is On (1) or Off (0) for
the Pre-Transaction Table for
selecting ARS/F-Route. If
enabled, this option sends dial
tone to the calling party once the
routing is determined. This may be
required if the central office at the
destination does not send dial
tone.
Set the Dial digits (24 digits max:
#
1~9, 0  , @) to be used for the
Dial Extension Analysis Table.
When Program 44-02-02 is set to
type 3, this program sets the dial
extension analysis table. These
tables are used when the
analyzed digits must be more than
eight digits. To enter a wild card/
don't care digit, press Line Key 1
to enter an @ symbol.
When dialed digits match the
setting in Program 44-03-01,
select the ARS/R-Route table
number (0~500) to be used for the
Dial Extension Analysis Table.
If the received digits are not
identified in tables 1~250, the
F-Route selection table number
(0~500) defined in table 251 is
used.
If the received digits do not match
the digits set in tables 1~250, table
number 252 is used to refer to the
next Extension Table Area (1~4)
to be searched.
UNIVERGE SV8100
Assigned Data
1
0 = Off
1 = On
(default = 0)

Up to 24 digits
Digits = 1~9, 0, , #, @
(Press Line Key 1 for
wild character @)
(default not assigned)
0~500
(ARS/F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
0~500
(ARS/F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
0~4
(default = 0)
Automatic Route Selection
Level
2 3



