NEC Univerge SV8100 Features And Specifications Manual page 335

UNIVERGE SV8100
Program
Program Name
Number
21-06-06 Toll Restriction Table Data Setup
– Permit Code Table
21-06-07 Toll Restriction Table Data Setup
– Deny Restriction Table
21-06-08 Toll Restriction Table Data Setup
– PBX Access Code
21-21-01 Toll Restriction for Trunks
(Seized Trunk Basis Setting) –
Restriction Class
34-01-05 E&M Tie Line Basic Setup –
System Toll Restriction
34-08-01 Toll Restriction Data for E&M Tie
Lines
35-02-01 SMDR Output Options – Toll
Restricted Call
Operation
To place a trunk call if your system is Code Restricted:
1. Place call normally.
If your Code Restriction Class does not allow the number you dial, your call is cut off.

Code Restriction
Description/Comments
Program codes into the Permit
Code Tables.
Program codes into the Restrict
Code Tables (200 codes per table
maximum).
The system allows up to four
tables for PBX access codes.
PBX Access Codes can have up
#
to two digits, using 0~9, ,  and
LINE KEY 1 (don't care). Refer to
the PBX Compatibility feature for
the specifics.
Enter the Toll Restriction Class for
the selected trunk.
Determine if an incoming Tie Line
call should be subject to Toll
Restriction.
Define the Toll Restriction data for
E&M Tie Lines. This data should
be defined if Tie Line Code
Restriction is enabled in Program
21-05-13.
SMDR can include or exclude calls
blocked by Toll Restriction.
Assigned Data
1
Dial (Up to 12 digits)

default:
Table 1~4 = No Setting
Dial (Up to 12 digits)

default:
Table 1~4 = No Setting
Dial (Up to two digits)
default:
Table 1~4 = No Setting

1~15
(default = 1)
0 = No (Off)
1 = Yes (On)
(default = 0)
Up to 10 digits
#
(0~9, , )
(default not assigned)
0 = Not Displayed
1 = Displayed
(default = 1)
Issue 5.0
Level
2 3




2 - 309