Subaru 2009 IMPREZA Service Manual page 3319

Clear Memory Mode
IMMOBILIZER (DIAGNOSTICS)
7. Clear Memory Mode
A: OPERATION
1. ECM
1) On «Main Menu» display, select {Each System
Check}.
2) On «System Selection Menu» display, select
{Engine Control System}.
3) Select [OK] after the information of engine type
is displayed.
4) On «Engine Diagnosis» display, select {Clearing
Memory}.
5) When "Done" is displayed on the display, end
the Subaru Select Monitor and turn the ignition
switch to OFF.
NOTE:
• After the memory is cleared, initial diagnosis of
the electronic throttle control is performed. Wait for
10 seconds or more after turning the ignition switch
to ON, and then start the engine.
• For detailed operation procedures, refer to "PC
application help for Subaru Select Monitor".
2. BODY INTEGRATED UNIT
1) On «Main Menu» display, select {Each System
Check}.
2) On «System Selection Menu» display, select {In-
teg. Unit}.
3) After {Integ. unit} is displayed, select [OK].
4) On «Integ. unit mode» display, select {Clearing
Memory}.
5) When "Done" is displayed on the display, end
the Subaru Select Monitor and turn the ignition
switch to OFF.
NOTE:
For detailed operation procedures, refer to "PC ap-
plication help for Subaru Select Monitor".
IM(diag)-9