Subaru 2009 IMPREZA Service Manual page 3269

EXTERIOR BODY PANELS
5) Fold the corners at the door upper end area in
the order of (1) - (3).
6) Cut off both ends of the rear door sash tape —
front.
7) Match the sash corner and the cut area of the
tape as shown in the figure. (Position of the arrow)
8) The lower end of the tape is to be aligned so that
a space of approximately 3.7 mm (0.15 in) remains,
so that the attachment holes of the weather strip
outer are not blocked. (Position of the arrow)
D-D
(1) Rear door sash tape — front
Door Sash Tape
(1)
(3)
(2)
EB-00417
EB-00410
(1)
D-D
3.7 mm
EB-00411
EB-30
9) Apply tape from the top of the vehicle towards
the bottom.
10) Fold the corners at the door upper end area in
the order of (1) - (2).
(2)
(1)
11) Thereafter, install door parts in the reverse or-
der of disassembly.
12) Install while paying attention to make a uniform
clearance around the rear door panel. For the di-
mension of clearance, refer to "SPECIFICATION"
in "General Description". <Ref. to EB-2, SPECIFI-
CATION, General Description.>
EB-00412
EB-00415