Subaru 2009 IMPREZA Service Manual page 3225

2. 4 DOOR MODEL
1) Remove the rear seat. <Ref. to SE-11, REMOV-
AL, Rear Seat.>
2) Remove the inside scuff plate. <Ref. to EI-55,
REMOVAL, Lower Inner Trim.>
3) Peel the trim, and use a screwdriver, etc. to
press claw (A) of the metal clip, to remove the quar-
ter upper trim.
(A)
CAUTION:
If the metal clip comes off or becomes dam-
aged, replace both the quarter upper trim rear
and metal clips.
4) Remove the seat belt lower anchor bolt.
5) Remove the cap (B) on the upper side of the rear
quarter trim, and remove the bolt inside.
(A)
NOTE:
Remove the molding (A), and remove the cap from
the backside of pillar trim not to damage the trim.
Rear Quarter Trim
EI-02326
SB-00353
(B)
EI-02291
6) Remove side belt cover (A).
7) Remove the bolts and clips, and remove the
quarter upper trim front.
8) Remove the rear seat. <Ref. to SE-11, REMOV-
AL, Rear Seat.>
9) Remove the clip of the trunk room side trim.
10) Remove the clips, then remove the quarter low-
er trim.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque
Refer to "COMPONENT" of "General Descrip-
tion".
Rear quarter upper trim (5 door model):<Ref.
to EI-19, INNER TRIM (5 DOOR MODEL),
COMPONENT, General Description.>
Rear quarter upper trim (4 door model):<Ref.
to EI-20, INNER TRIM (4 DOOR MODEL),
COMPONENT, General Description.>
Seat belt anchor:<Ref. to SB-3, REAR SEAT
BELT, COMPONENT, General Description.>
EI-59
EXTERIOR/INTERIOR TRIM
(A)
EI-02292
EI-02327
EI-01906