Subaru 2009 IMPREZA Service Manual page 3260

Hide thumbs Also See for 2009 IMPREZA:

B: INSTALLATION

1) Put a wooden block on jack and place the front

door on that.

2) Apply grease to the sliding area of door hinges,

and install the door hinge to vehicle.

3) Install the front door to upper hinge and lower

hinge adjusting by jack.

4) Tighten bolt of door checker.

5) Connect door harness connector, and install the

instrument panel lower cover.

6) Install the front pillar lower trim.

Tightening torque:

Refer to "COMPONENT" of "General Descrip-

tion". <Ref. to EB-11, REAR DOOR, COMPO-

NENT, General Description.>

7) Install while paying attention to make a uniform

clearance around the front door panel. For the di-

mension of clearance, refer to "SPECIFICATION"

in "General Description". <Ref. to EB-2, SPECIFI-

CATION, General Description.>

C: ADJUSTMENT

1) Using the ST, loosen the body-side bolts of up-

per and lower hinges to align the vertical and hori-

zontal positions of the front door panel.

ST 925610000

2) Loosen the screw (A) and tap striker (B) using

plastic hammer to adjust the gap between rear end

surface of front door panel and front end surface of

Do not use an impact wrench. Welding area on

the striker nut plate is easily broken.

EXTERIOR BODY PANELS