Subaru 2009 IMPREZA Service Manual page 3235

Hide thumbs Also See for 2009 IMPREZA:

30.Rear Gate Garnish

1) Remove the rear gate trim. <Ref. to EI-66, RE-

MOVAL, Rear Gate Trim.>

2) Remove the rear wiper motor. <Ref. to WW-19,

Rear Wiper Motor.>

3) Remove the rear finisher light. <Ref. to LI-26,

REMOVAL, Rear Finisher Light Assembly.>

4) Disconnect the connector.

• Rear gate opener button harness connector

• Rear request switch harness connector (Smart

keyless models)

5) Remove the nuts.

6) Remove the clips, and remove the rear gate gar-

B: INSTALLATION

Make sure that the harness grommet is secure-

ly installed.

If not properly installed, this may cause leaks.

Install in the reverse order of removal.

Tightening torque:

4.5 N·m (0.46 kgf-m, 3.3 ft-lb)

Rear Gate Garnish

EXTERIOR/INTERIOR TRIM