Wireless Access Points; Access Point Status - HP MSM3xx Management And Configuration Manual

Wireless access points

To view wireless information for the AP, select Status > Wireless.
The information you see will vary depending on the AP. For example, this is the status page
on an MSM422.

Access point status

Wireless port
UP: Port is operating normally.

 DOWN: Port is not operating.
Frequency
The current operating frequency.
Protocol
Identifies the wireless protocol used by the AP to communicate with client stations.
Mode
Current operation mode.
Tx power
Current transmission power.
Transmit protection status
(Only on the E-MSM430, E-MSM460, E-MSM466)
 Disabled: HT protection / G protection is disabled.
 B clients: G protection is enabled because a B client is connected to the AP.
 B APs: G protection is enabled because a B client is connected to another AP on the
same channel used by the AP.
 AG clients: HT protection is enabled because a non-HT client is connected to the AP.
 AG APs: HT protection is enabled because a non-HT AP is present on the same channel
used by the AP.
Tx multicast octets
The number of octets transmitted successfully as part of successfully transmitted multicast
MSDUs. These octets include MAC Header and Frame Body of all associated fragments.
Tx unicast octets
The number of octets transmitted successfully as part of successfully transmitted unicast
MSDUs. These octets include MAC Header and Frame Body of all associated fragments.
Wireless configuration
Viewing wireless information
3-39