Table of Contents
Advertisement
HP MSM313/MSM323 Deployment Guide
5. On the Add/Edit Virtual Service Community page:
• Under General, set Name to Public.
• Under VSC ingress mapping, clear the SSID checkbox.
• Under VSC egress mapping, select VLAN and then select Public.
• Enable HTML-based user logins.
• Select the RADIUS authentication checkbox.
• For RADIUS Profile, select RADIUS1.
• Click Save.
F. Set the shared secret
1. Select Public access > Access control.
2. In the Access controller shared secret box, set Shared secret and Confirm shared secret
to a unique string. For example: xr2t56. This password will be used by the APs to send
authentication requests to the service controller.
3. Click Save.
Configure the APs
A. Set static addressing and management VLAN
1. Select Network > Ports.
2. Under Port configuration, click Bridge port.
• Under Assign IP address via, select Static then click the Configure button. Define the
following:
• For each AP, set IP address to a unique address on the 192.168.30.x subnet.
• Set Address mask to 255.255.255.0.
• Set Default gateway to 192.168.30.1.
• Click Save.
B. Configure management VLAN
1. Select Network > Ports.
2. Under Port configuration, click Port 1.
• Under VLAN
• Select the VLAN ID checkbox.
• Set VLAN ID to 30.
• Select the Restrict default VLAN to management traffic only checkbox.
• Click Save.
43
2 Public/guest networks
Advertisement
Table of Contents
