Set Wep Encryption For Each Wireless Interface - HP WL520 User Manual

NOTE:
Not all software features available for the 802.11b cards are available for the 802.11a cards.
1. In the Web Interface, click the
2. Select the Wireless A or the Wi i reless B tab. Wireless A Wireless A Wi ele r
3. Enter Network Names (SSID) for the PC Cards in wireless Slots A and/or B in the WL520 device.
4. Select OK. O O K K
OK

set wep encryption for each wireless interface

set wep encryption for each wireless interface set wep encryption for each wireless interface set wep encryption for each wireless interface
Figure 2-8 Figure 2-8 Figure 2 8 Figure 2- - 8 WEP Encryption WEP Encryption W WEP Encryption EP En cryption
1. In the Web Interface, click the
NOTE:
If you want to use 802.1x security, see
2. Select the
Encryption Encryption
Encryption Encryption
3. Click the check box to
4. Type in an Encryption key Encryption key
Encryption key Encryption key
characters (a-z, A-Z, and 0-9) or hexadecimal digits (A-F, a-f, and 0-9).
NOTE:
The WL520 device supports 802.11b cards that use 64-bit or 128-bit encryption. For 802.11a, the WL520 device
supports 64-bit, 128-bit, or 152-bit encryption. 64-bit encryption supports key lengths of 5 alphanumeric characters
or 10 hexadecimal digits. 128-bit encryption supports key lengths of 13 alphanumeric characters or 26 hexadecimal
digits. 152-bit encryption supports key lengths of 16 alphanumeric characters or 32 hexadecimal digits.
button and select the
Configure Configure Configure Configure
ss A Wireless B W re Wireless B less B
button and select the
Configure Configure Configure Configure
IEEE 802.1x Security
sub-tab.
enable Encryption (WEP) enable Encryption (WEP)
enable Encryption (WEP) enable Encryption (WEP)
based on the type of card present in each slot. You can enter the key in either ASCII
tab.
Interfaces Interfaces Interfaces Interfaces
tab.
Security Security Security Security
Mode.
on a wireless card.
2-7