Interface Commands - HP ProCurve 420 Management And Configuration Manual

Command Line Reference

Interface Commands

6-60

Interface Commands

The commands described in this section configure connection parameters for
the Ethernet interface and wireless interface.
Command
General Interface
interface
Ethernet Interface
dns primary-server
dns secondary-server
ip address
ip dhcp
shutdown
speed-duplex
show interface ethernet
Wireless Interface
radio-mode
antenna-mode
description
closed-system
speed
multicast-data-rate
channel
ssid
beacon-interval
Function
Enters specified interface configuration mode GC
Specifies the primary name server
Specifies the secondary name server
Sets the IP address for the Ethernet interface IC-E
Submits a DHCP request for an IP address
Disables the Ethernet interface
Configures speed and duplex operation
Shows the status for the Ethernet interface
Sets the radio working mode
Sets the access point's antenna mode
Adds a description to the wireless interface
Closes access to clients without a pre-
configured SSID
Configures the maximum data rate at which a IC-W
station can connect to the access point
Configures the maximum data rate at which the IC-W
access point can transmit multicast traffic
Configures the radio channel
Configures the service set identifier
Configures the rate at which beacon frames
are transmitted from the access point
Mode Page
6-62
IC-E 6-62
IC-E 6-62
6-63
IC-E 6-64
IC-E 6-65
IC-E 6-66
Exec 6-66
IC-W 6-67
IC-W 6-68
IC-W 6-68
IC-W 6-69
6-70
6-70
IC-W 6-71
IC-W 6-72
IC-W 6-73