Show" Cli Command; Configuring The Hp Wl520 Unit Using Cli Commands; Log Into The Hp Wl520 Unit - HP WL520 User Manual

"show" cli command

"show" cli command
"show" cli command "show" cli command
Displays the value of specified parameter, or displays all parameter values of a specified group (parameter table). Groups
contain Parameters and Tables. Tables contain parameters for a series of similar entities.
To see a definition and syntax example, type only show and then press the Enter key. To see a list of available parameters,
enter a question mark (?) after show (example:
Syntax:
[Device Name]>show <parameter>
[Device Name]>show <group>
[Device Name]>show <table>
Examples:
[Device Name]>show ipaddr
[Device Name]>show network
[Device Name]>show snmpipaccesstbl
configuring the configuring the configuring the configuring the hp hp WL520 hp hp
log into the hp log into the hp WL520 WL520 unit
log into the log into the hp hp WL520 WL520
The CLI commands can be used to access, configure, and manage your HP WL520 device using Telnet or a terminal
emulation application, such as HyperTerminal. Log into the HP WL520 unit using Telnet:
1. Go to the DOS command prompt on your computer.
2. Type in telnet <IP Address of the unit>.
3. Enter the Telnet password (default is public).
NOTE:
We recommend changing your default passwords immediately. To perform this operation using CLI commands, refer
to Change passwords.
log into the log into the log into the hp log into the hp hp WL520 hp WL520 unit using WL520 WL520
1. Launch HyperTerminal from the
following settings:
Com Port: <COM1, COM2, etc., depending on your computer>
Baud rate: 9600
Data Bits: 8
Stop bits: 1
Flow Control: None
Parity: None
2. Enable the "ASCII Setup" settings by selecting "
(Result: HyperTerminal sends a line return at the end of each line of code.)
3. Enter the Telnet password (default is public).
NOTE:
We recommend changing your default passwords immediately. To perform this operation using CLI commands, refer
to Change passwords.

Configuring the hp WL520 unit using CLI commands

).
show ? show ? show ? show ?
WL520 unit using cli commands WL520 WL520 unit using cli commands unit using cli commands unit using cli commands
unit
unit unit
unit using unit using unit using H H H H yperterminal yperterminal yperterminal yperterminal
Start > Programs
Send line ends with line feeds
menu. Open an existing connection or create a new one with the
".
6-12