Configuring The Wl520 Unit Using Cli Commands; Log Into The Wl520 Unit Using Hyperterminal; Log Into The Wl520 Unit Using Telnet - HP WL520 User Manual

configuring the wl520 unit using cli commands

configuring the wl520 unit using cli commands
configuring the wl520 unit using cli commands configuring the wl520 unit using cli commands

log into the wl520 unit using hyperterminal

log into the wl520 unit using hyperterminal
log into the wl520 unit using hyperterminal log into the wl520 unit using hyperterminal
1. Launch HyperTerminal from the
following settings:
Com Port: <COM1, COM2, etc., depending on your computer>
Baud rate: 9600
Data Bits: 8
Stop bits: 1
Flow Control: None
Parity: None
2. Enable the "ASCII Setup" settings by selecting "
(Result: HyperTerminal sends a line return at the end of each line of code.)
3. Enter the CLI password (default is public).
NOTE:
We recommend changing your default passwords immediately. To perform this operation using CLI commands, refer
to Change Passwords.

log into the wl520 unit using telnet

log into the wl520 unit using telnet log into the wl520 unit using telnet log into the wl520 unit using telnet
The CLI commands can be used to access, configure, and manage your WL520 device using Telnet or a terminal emulation
application, such as HyperTerminal. Log into the WL520 unit using Telnet:
1. Go to the DOS command prompt on your computer.
2. Type in telnet <IP Address of the unit>.
3. Enter the CLI password (default is public).
NOTE:
We recommend changing your default passwords immediately. To perform this operation using CLI commands, refer
to Change Passwords.
Configuring the WL520 Unit using CLI commands
menu. Open an existing connection or create a new one with the
Start > Programs Start > Programs Start > Programs Start > Programs
Send line ends with line feeds Send line ends with line feeds Send line ends with line feeds Send line ends with line feeds
".
6-13