Table of Contents
Advertisement
Loading Paper/Changing
2.2
Paper Size of Paper Trays
This section explains how to load paper into and change the paper size of trays 1-4, tray 5 (bypass) and the
optional tray (HCF) and 7.
If paper runs out during copying, the following message will be displayed: "Tray x is out of paper. Load xx paper
into the tray." (where x refers to the tray number and xx the paper size). Add paper to the tray accordingly.
The type of paper that can be loaded differs for each tray. For details, refer to "2.1 Paper to Use".
Change the paper type setting if you need to change both the paper size and type.The paper type setting is changed by the
administrator. For details, refer to "2.3 Checking/Changing Paper Supply Settings".
Always pull out a tray slowly. The tray may hit and hurt your knees if it is pulled out too
quickly with excessive force.
2.2.1
Loading Paper in Trays 1, 2, 3, 4
No change in site and orientation can be made for tray 1 as it is fixed at A4 portrait.
You can change the paper size and orientation for trays 2, 3, 4, but you can only change the paper
size to standard sizes for trays 2, 3, 4.
The paper sizes for loading in the paper trays can be changed by the customer engineer. The paper size for tray 1 can be
changed to A5, B5 portrait, or 8.5×11" portrait; and for trays 2 – 4, 12×18" or any non-standard sizes within the range of 182-
297mm (Y direction) and 182-432mm (X direction).
During copying, paper can be added to trays not in use.
Do not load different types of paper
in the tray. This may result in paper
jam.
Do not load paper exceeding the
maximum fill line.
Procedure
1
Pull the paper tray out
right to the end.
2
Load the paper, aligning to
the left side of the tray and
with the side to be copied
facing down.
25
Advertisement
Table of Contents
Troubleshooting
