Ethernet Port - NEC EXIFU-A1 Installation, Configuration And Operation

Ethernet Port

The Ethernet port of the XN120 is used for the following feature.
PC Programming – PC based application used to configure the XN120 system
The Ethernet port will operate when the EXIFU-A1 card is installed, there is no configuration required in order
to use PC Programming.
The Ethernet port is assigned the following fixed IP address and subnet mask.
IP Address = 172.16.0.10
Sub Net Mask = 255.255.0.0
This guide shows the configuration required to connect the XN120 to the customers Ethernet LAN. This will
enable you to access PC Programming from another PC connected to the customers LAN.
! You will need a fixed IP address and the appropriate Sub Net Mask for the XN120, this must be
specified by the Network Administrator responsible for the customers LAN.
Program 10-12-01
1
Enter the IP Address of the
XN120 system.
Enter the Sub Net Mask.
You must power the XN120
system off/on for the new IP
address to take effect.
Configuration Sheet : Ethernet port
Program 10-12-01
Program 10-12-02
XN120 EXIFU Guide
Ø Enter the IP Address, you must enter three digits for each
Ø Press HOLD to confirm the entry.
Ø Enter the Sub Net Mask, you must enter three digits for each
Ø Press DC several times when you are done to return to the
Ø (Press SPK to save changes and exit if you are finished).
IP Address =
Sub net mask =
10-12-01
172.16 .0
field. Example 172 016 000 010 you do not need to enter the
decimal points.
10-12-02
255.255.0
field. Example 255 255 000 000 you do not need to enter the
decimal points.
Program Mode.
Ethernet Port
.10
Enter the IP Address
of the XN120 system
.0
Enter the Sub Net
Mask
13