Enabling serial port echo
Enable or disable to allow the CLI command pass through.
1. Select Menu > Configuration > Communications > Serial Port Echo.
2. To swap, select ENTER.
Setting the projector address
Assign an address to the projector for IR remote connection.
1. To set the projector address, select Menu > Configuration > Communications > Projector
Address.
2. Select specific number for this projector from 0 to 9.
3. To match up with the projector address, select PROJ and specific number key.
The projector responds to the IR remote set to the same address as the projector or to the IR
remote set to address 0.
Adjusting the back light settings
Control the back light behavior and timeout setting for the keypad and status LED.
1. Select Menu > Configuration > Backlight Preferences > Status LED.
2. Select the appropriate setting for status LED.
3. To confirm the selection, select ENTER.
Setting the hot key
To directly call out a function without going through the layers of the on-screen display (OSD)
menus, select a specific function for a hot key. User can call this function by selecting the HOT KEY
on remote control.
1. Select Menu > Configuration > Hot-Key Settings.
2. Select the one function for the hot key:
•
Size Presets
•
Picture Settings
•
Default Value
•
Detail
•
Contrast Enhancement
•
Light Source Mode
•
Image Freeze
•
Information
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring communications
61