Double-Size Network Interface Unit - Alaxala AX6300S Series Instruction Manual

Figure 5-37 Installing a network interface unit (4)
(1) Screws
NOTE
NOTE

5.6.2 Double-size network interface unit

(1) Removing a double-size network interface unit
A network interface unit can be removed while the Switch is on.
Note, however, that the procedure varies depending on whether the Switch is on or
off.
Install the unit while referring to the following figure.
NOTE
5. Adding and Replacing Optional Modules
Use a screwdriver to tighten the screws. Make sure the screws are
firmly tightened.
If you install a network interface unit (NIF) while the Switch is on, the
NIF is turned on automatically when the NIF is installed.
Note, however, that if no power enable is set in the configuration, the
NIF is not turned on automatically. Set power enable, and then turn on
the power.
For details about the
power enable
of BSU/NIF in the Software Manual Configuration Guide Vol. 1.
For details about steps 1 to 5 in the figure, see the description of the
steps that follow Figure 5-38 Overview of removing a network
interface unit.
command, see 12. Management
177