Alaxala AX6300S Series Instruction Manual page 58

1. Components Overview
Name
T/R
#1: A network interface unit can be turned off by the Inactivate operation from the
system operation panel or by entering a command from the operation terminal.
#2: If no system recovery is set, the network interface unit is turned off in the
following situations:
When a failure occurred in the network interface unit (the STATUS LED turns
red, and then it turns off).
When a failure occurred in a management and switching unit (when the
management and switching unit is not duplicated).
#3: When the STATUS LED is green.
#4: Cable disconnection is also included.
#5: Operation of an Ethernet port can be stopped by entering a command from the
operation terminal.
#6: Always turns off if the interface port LED is set to off. When an operation key on
the system operation panel is used, the LED lights up, and the operating status can
be checked. If no keys are used for 60 seconds, the LED turns off again.
NOTE
(7) NH10G-8RX
The NH10G-8RX is a network interface unit with the following hardware
specification:
Ethernet port (10GBASE-R): 8 ports
NOTE
Front view
The front view is shown below.
For information about LEDs, see Table 1-19 LED indications.
Figure 1-30 Front view
34
Type
LED: Green
If no system recovery is set and a failure occurs in a Switch, the
Switch can stay stopped without recovering the failed part.
This function is supported by software version 10.3 and later.
For information about the XFP transceivers supported by the Switch,
see 1.7.2 XFP.
Status
Blinking green: A frame is being sent
or received.
Off: No frames are being sent or
received.
Description