4.10 Inserting and removing XFP transceivers
XFP transceivers with a network interface unit attached can be inserted and
removed while the Switch is on.
NOTE
(1) Installing an XFP transceiver
Keep the lever upright as shown in the figure, and insert the XFP transceiver until
you hear a click.
Figure 4-42 XFP transceiver
(1) XFP transceiver
(2) Lever
(3) Ethernet port
(2) Removing an XFP transceiver
Press the lever down in the direction of the arrow. While holding down the lever, pull
out the XFP transceiver.
Figure 4-43 Removing an XFP transceiver
(1) Lever
The following procedures describe how to insert and remove a type-A
module. The same procedures apply to a type-B module.
4. Installing a Switch
121