4. Installing a Switch
Step 2
Remove the terminal board cover from the terminal board.
Figure 4-26 Removing the terminal cover
(1) Terminal cover
Step 3
Remove the 0 V terminal, −48 V terminal, and ground terminal screws.
Figure 4-27 Removing the screws
(1) 0V terminal
(2) −48 V terminal
(3) Ground terminal
(4) Screws (M6)
NOTE
Step 4
Loosen the cable clamp screws.
110
If a two-hole type bracket (shown in the following figure) is used for the
ground terminal, remove both screws of the ground terminal.