4.4 Replacing the rack fixture
A rack fixture attached to a Switch is used to secure the rack pillars and the front of
the Switch so that they are flat when the Switch is installed in a rack.
If you purchased an optional fixture, which secures the Switch so that it is recessed
50 mm, use the following procedure to replace the rack fixture.
4.4.1 AX6304S
Step 1
Remove the rack fixture that was attached to the Switch when it was shipped from
the factory.
Figure 4-2 Removing the rack fixture
(1) Left: L
(2) Right: R
(3) Screws
NOTE
Step 2
Attach the optional rack fixture.
Make sure you keep the rack fixture and screws you remove.
4. Installing a Switch
91