Alaxala AX6300S Series Instruction Manual page 15

Do not install the Switch in a dusty or humid location.
Do not install the Switch in a dusty or humid location. Doing so could result in fire or
electric shock.
Condensation might form on the surfaces and the inside of the Switch if it is moved
from a cold location to a warm location. Using the Switch in this condition could
result in fire or electric shock. After moving the Switch between two locations with a
large temperature variation, let the Switch stand a few hours before using it.
Do not stack Switches.
Do not stack Switches. Doing so might damage the Switch. Furthermore, the Switch
might fall, or become unbalanced, resulting in injury.
Do not step on the Switch, lean against it, or place anything on it.
Do not step on the Switch, lean against it, or place anything on it. Doing so might
damage the Switch. Furthermore, the Switch might fall, or become unbalanced,
resulting in injury.
When mounting a Switch into a rack, use a fixture that can support the
weight of the Switch.
It is not possible for the provided rack fixture alone to support the weight of a Switch.
Its purpose is merely to hold a Switch in the rack. Accordingly, use the following
fixtures:
AX6304S : Guide rails, shelves, and support brackets
AX6308S : Guide rails and shelves
You must use the guide rails and shelves provided with the rack, and these must be
able to support the weight of the Switch (with the maximum number of optional
modules installed).
Do not use support brackets with a Switch other than the AX6304S.
The support bracket supports the AX6304S only. Do not use the bracket with
another Switch.
Using a bracket with another Switch might cause the Switch to drop or fall, resulting
in injury.
Be careful when using support brackets.
When using support brackets to mount a switch on a rack, hold the front and back of
the Switch and mount it horizontally. You must hold the Switch until the screws have
been tightened. If the Switch tilts, it could drop or fall, resulting in injury. In addition,
other devices mounted in the same rack might be damaged.
When support brackets are used to mount a Switch on a rack, the weight of the
Switch is borne by the rack fixture and the support brackets only. Securely tighten
the screws on the rack fixtures and the support brackets.
Safety Information
Safety-7