Alaxala AX6300S Series Instruction Manual page 120

4. Installing a Switch
Figure 4-7 Installation location of the guide rail
(1) Rubber pad
(2) Guide rail
(3) Rack pillar
NOTE
NOTE
Step 2
Mount the Switch on the guide rails or the shelf. Hold the bottom and the handles of
the Switch when mounting the Switch.
Figure 4-8 Mounting a Switch on the rack
(1) Handles
(2) Rack
96
Dotted lines (- - -) in the Figure indicate the boundary between units
(U). When attaching a guide rail, align the top of the guide rail with the
boundary (U).
Rubber pads are attached to the bottom of a Switch when it is shipped
from the factory. The height of a rubber pad is 0.7 mm. When using a
shelf, adjust it so that it is 0.7 mm below the boundary (U).