Alaxala AX6300S Series Instruction Manual page 93

can use an optional fixture that secures the Switch so that it is recessed 50 mm
from the rack pillar. For information about this separately sold fixture, see 1.10 Rack
fixture.
Table 2-15 Required brackets
Bracket AX6304S
Guide rail
Shelf
Support bracket
Legend
Y: Can be used.
--: Cannot be used.
#1: Install the guide rail in the location described in 4.5 Mounting in a rack.
#2: Rubber pads for the Switch are attached 56 mm inward from the side of the
Switch. Use a guide rail with a width of 56 mm or less so that it does not touch the
rubber pads (see Figure 2-11 Guide rail details).
Figure 2-11 Guide rail details
(1) Rubber pad
(2) Guide rail
(3) Rack pillar
It is not possible for the provided rack fixture alone to support the
weight of a Switch. Its purpose is merely to hold a Switch on the rack.
Accordingly, use the following fixtures:
You must use the guide rails and shelves provided with the rack, and
these must be able to support the weight of a Switch (with the
maximum number of optional modules installed).
Table 2-16 Number of required screws
Purpose
When a guide For securing
rail or shelf is guide rails and
used shelves
AX6308S
Y Y
Y Y
Y --
AX6304S : Guide rails, shelves, and support brackets
AX6308S : Guide rails and shelves
AX6304S
(Note 1)
2. Preparation for Installation
Specifications
Supplied with the rack. The width must
#1 #2
be 56 mm or less.
#1
Supplied with the rack.
Sold separately. Only for the AX6304S.
AX6308S Specifications
(Note 1) Supplied with
the rack. M5 or
M6 screws.
69