Alaxala AX6300S Series Instruction Manual page 164

4. Installing a Switch
(2) Turning off the power
Step 1
Make sure the software is not being updated (the
executed) and the memory card is not being accessed.
Figure 4-63 Checking the LED
(1) Management and switching unit
(2) STATUS LED
(3) ACC LED
CAUTION
CAUTION
Step 2
Set all power switches of the Switch to ON.
140
When the command is executed, the Switch restarts
ppupdate
automatically.
Do not turn off the Switch until it is restarted (until the STATUS LED on
the management and switching unit changes from blinking green to
constant green). Failure to do so could result in a Switch failure.
If the ACC LED is lit, the memory card is being accessed. While a
memory card is being accessed, do not remove the memory card or
turn off the power. Doing so might damage the memory card.
In addition, some commands require a certain amount of time after
being entered to finish accessing the card. Make sure that the memory
card is no longer being accessed before removing the card or turning
off the power.
command is not being
ppupdate