Alaxala AX6300S Series Instruction Manual page 135

Figure 4-28 Releasing the cable clamp
(1) Cable clamp
(2) Screws (M5)
Step 5
Pass the DC power cable through the cable clamp, and then tighten the screws of
the ground terminals.
Figure 4-29 Securing the ground terminals
(1) DC power cable
(2) Cable clamp
(3) Ground terminal
(4) Screws (M6)
NOTE
If you use a DC power supply, always connect the ground terminals.
Using the Switch without grounding could result in electric shock or
failures due to electrical noise.
If a two-hole type bracket (shown in the figure below) is used for the
ground terminal, use two screws to secure the ground terminal.
4. Installing a Switch
111