Alaxala AX6300S Series Instruction Manual page 59

(1) STATUS LED
(2) LINK LED
(3) T/R LED
(4) Ethernet port (10GBASE-R)
LED
Table 1-19 LED indications
Name Type
STATUS LED: Green,
orange, or red
LINK LED: Green or
Orange
T/R LED: Green
#1: A network interface unit can be turned off by the Inactivate operation from the
system operation panel or by entering a command from the operation terminal.
#2: If no system recovery is set, the network interface unit is turned off in the
following situations:
When a failure occurred in the network interface unit (the STATUS LED turns
red, and then it turns off).
When a failure occurred in a management and switching unit (when the
management and switching unit is not duplicated).
#3: When the STATUS LED is green.
#4: Cable disconnection is also included.
#5: Operation of an Ethernet port can be stopped by entering a command from the
operation terminal.
#6: Always turns off if the interface port LED is set to off. When an operation key on
the system operation panel is used, the LED lights up, and the operating status can
be checked. If no keys are used for 60 seconds, the LED turns off again.
NOTE If no system recovery is set and a failure occurs in a Switch, the
Switch can stay stopped without recovering the failed part.
This function is supported by software version 10.3 and later.
Status
Indicates the operating
status of the network
interface unit.
Indicates the operating
status of the Ethernet
#6
port.
1. Components Overview
Description
Green: Operation is possible.
Orange: A reset is in progress.
Blinking green: Startup is in
progress.
Red: A failure has been
detected.
Off: Power is off. (The network
interface unit can be
#1 #2
replaced.)
Green: A link is established.
Orange: A failure has been
detected.
Off: A link failure occurred
#3 #5
operation has stopped.
Blinking green: A frame is being
sent or received.
Off: No frames are being sent or
received.
#3 #4
or
35